Dry Cell Kit For Truck Engines Up To 18 Liters

We have designed this kit so you will receive all the parts needed to have a successful HHO system installation for an engine up to 18 liters. Each kit includes the following:

1. 1 x Triple Stack 12" x 12" x 6" HHO Dry Cell Generator (19 plates). This cell weighs 39 lbs without electrolyte.
2. Pulse-Width Modulator (PWM). Our PWM comes with a remote display unit that you can mount in the passenger compartment that will show you your amp draw, pulse frequency, and duty cycle (the percentage of the time that the voltage is high vs the time the voltage is low during each pulse).
3. Electronic Enhancer needed for your vehicle.
4. 2.5 Gallon electrolyte reservoir with cap and fittings.
5. Advanced Dryer Assembly
6. 25' of heavy-duty 3/8" hose.
7. 25' each of red and black 4 gauge wire.
8. PWM Installation Panel: Includes all of the components of your PWM system are prebuilt onto a panel that you can easily mount on the front of your cell, ready to connect your Display/Controller in your cab.
9. System installation kit: Includes all the connectors, screws, check valves, drain valve, etc that you need to complete a full installation of your HHO system