Truck PWM - Master or Slave

This is for Truck PWMs where the PWMs will be combined in a master/slave relationship with a single controller. These PWMs have been upgraded from their equivalent car PWM as follows:

1. All new, higher capacity mosfets
2. Each mosfet is bonded to the heat sink with Arctic Silver Heat Sink Paste, and mechanically bolted using special washers that distribute the pressure evenly across the face of the mosfet.
3. New mosfet driver that handles 3X the current.
4. 3 large inductors to absorb voltage spikes coming back from large cells
5. New 2 Amp transistor to drive the mosfet drivers.

These PWMs can be combined to share larger loads. They were developed to run our large Truck cells. If you are blowing up smaller PWMs, this is the most robust PWM on the market that we know of. While each PWM can handle 40 amps, we recommend figuring it at 25 amps max for continuous loads. Therefore, if you need 100 amps, buy one controller, and 4 of these PWMs. You should specify in the shipping instructions that these are to be run as a single system, and we will configure the PWMs and controller for you.